Routing/ Scoring

Routed tracks
Elprint standard router size is 2.4 mm (94 mil or 3/32 inch). Elprint recommends using this size unless another size is specifically necessary. Minimum router size is 0.8 mm (31 mil or 1/32 inch).

Plated tracks must have at least 0.5 mm (20 mil) copper around all sides of the track. Elprint standard tool size for plated tracks is 1.5 mm, which gives a 1.45 mm (57 mil) slot after plating.

Unplated tracks should have a copper-free area of at least 0.15 mm (6 mil) around the edges.

Boards with plated edges
Boards with plated edges must be manufactured within a customer panel. The board edges must be produced as plated tracks.

Scoring (v-cut)
Panels with v-cut between the individual boards should have a spacing of 0.6 mm (24 mil) between the boards. Copper should be kept at least 0.3 mm (12 mil) from the board edges.